1 laser 2 corresponding to the controller laser signals (Page 67 / 76) RDWorks V8 Laser Engraving Cutting Software User Manual

Laser Engraving Cutting Software User Manual----RDCAM V8.0

Laser 1, laser 2: corresponding to the controller laser signals channel 1 and channel 2 output. If it

is only head machine, the channel 2 laser is meaningless.

The minimum power, the maximum power: the power values range is 0 to 100, which means

the laser strong or weak in processing; Big value, the laser is strong; small value, the laser is weak.

Minimum power is less or equal to the maximum power.

Different processing types have different meanings.

For cutting processing, the actual power is followed with cutting speed, lower speed, lower energy,

high speed high energy, so that we can guarantee the whole process of cutting energy evenly. So

the minimum power corresponding to the energy at minimum speed, generally the minimum speed

is 0, but if set takeoff speed, so the minimum speed is takeoff speed; the maximum power

corresponds to the layer speed.

The minimum power and the maximum power setting procedure:

1> Setting the minimum power and the maximum power as the same value, synchronous

adjustment. Until all the cutting curves are already appear.

2> The maximum power is fixed, and reduce the minimum power gradually until the energy of the

cutting curve at the lowest level, and all the connecting parts can be processed.

3> If not yet to the best effect, you can fine-tune the maximum power, and repeat step 2.

If cut through, the minimum power and the maximum power have no significant differences,

which can be set to the same.

For scan processing, ordinary scanning, the minimum power and the maximum power must be

consistent. When slope engraving, the minimum power is the power of the slope crest, the

maximum power is the power of the slope bottom.

Minimum power is smaller, so the slope crest is wider, the details are undistinguished.

Minimum power is larger, slope is not obvious.

For dotting processing, set the minimum power and the maximum power the same.

If checked "default", the actual power is determined by panel setting power.

Click the button "advanced", you can set other layer parameters.

67 / 76